I own a small welding shop that should employ 6 people, but currently has 3 1/2. I try to read as much as I can on the “zone”, but unfortunately, my time is limited.
I recently purchased a small cnc router that uses a dremel from a member here. I’m planning to learn as much about CNC as I can with this lil gizmo, and have some fun along the way, as I slowly understand more and more, about the various components and software, that is involved with CNC equipment.
So far, I’m sticking with image carving, and when I learn the do’s and do nots of that, I’ll move on. A few of my carvings are shown here…
For the moment, one of the things that I would like to do, would be to hook up the dremel tool to the control, so it can be programmed to shut off when its done. If anyone can point me to which topic that fits under the best, I’d greatly appreciate it.
The long range goal, is to build a CNC Plasma table to replace my current plasma/oxy-acc set up. I currently have an old Koike “pantograph” table… at least thats what I call it.
My “Howdy” is longer winded than was intended… and I just ran out of breath!